Reos Lite E2713W LED Smart Bulb (1100Lumens)
- Bulb Base: E27, Color Temperature: 6500K, Lumens: 1100lm
- Wattage: 13 watts, Operating Voltage: 115-260 volts
- Included Components: LED Bulb
- Adjustable colour temperature (2700K to 6500K), 15000 hours life, bluetooth 4.0
- Energy efficient
- Instant alerts (weather, SMS, whatapp, facebook, tinder etc.)
- Schedule on/offs
- Reading, party and movie modes
Single Beam 15 m Photoelectric Active Infrared Intrude Detector IR Sensor Tamper Alarm
- Working Voltage: 12V, 24V
- Working Current: 50MA
- Infrared Frequency: 1.92khz
- Wavelength:940nm
- With rain-proof design
- Operating temperature: --20 degrees to 50degrees
- Relay output : 1 a max *36 v
- Response time(Relay output) <10 ms,
- Hold time(Relay output) 300ms
- Range can be reduced to 30% in bad weather conditions: for rain , dust , etc
- Unique digital filter circuit design, strong anti false alarm ability
- With high levels of anti-RFI/EMI capability
- Fully sealed design, rain-proof(fog),dust-proof(worm),suitable for hostile environment
- Used with kinds of alarm panel and access control system.
- Detector Range: indoor 20m. Outdoor 10m, Detection mode Presence(beam interruption)
- Size : 49.2 x 76 x 21.6MM,
KX931 Travel Plug
Wall Mount Sound Security Light Delay Sensor Control Lamp Switch Ac 220V
- Operating voltage: 220v
- Load Power: 30w
- Sound Control Sensitivity: 95db- 75db
- Light Control Induction: 6lux
- Delay Time: 30 seconds
- High-quality Energy Saving Auto Switch Controlled by Light and Sound
- Ideal Light Switch for use around bathroom, hallways, staircases and porches
- Easy to install
- Load Type: Control energy-saving lamps under 80W,incandescent under 60W,LED light under 30W
- Installation: Shut off the power, load must not short-circuit
- Light ON automatically when sound is detected in the dark, when in daytime or under strong light, circuit in the off state and the light does not turn on.
- Dimension: 6 X 5 x 2.6Cm
6-30V 1-Channel Power Relay Module with Adjustable Timing Cycle
- Operating voltage: 6 - 30V DC
- 1 Channel delay trigerred relay module
- Delay time: 0.1 second ~ 999 minutes
- Seven Segment Display
- Operating voltage: DC 6V-30V (supports micro USB 5V power supply)
- Trigger signal source: high-level trigger (3V-24V) signal ground and system to improve the system's anti-jamming capability (also short-circuit altogether)
- Output capability: it can control the device within DC 30V 5A or within AC 220V 5A
- Quiescent current: 20mA
- Operating current: 50mA
- Service life: more than 100,000 times
- Working temperature: -40°C-85°C
- With optocoupler isolation, enhanced anti-jamming capability, industrial grade circuit board, set parameters for memory after power failure.
- Dimension: 6.2 * 3.8 * 1.7cm
E27 PIR Infrared Motion Sensor LED Light Lamp Holder Control Switch
ESP8266- 01 5V WIFI RELAY MODULE TOI APP CONTROLLED FOR SMART HOME AUTOMATION
- Onboad module: ESP2866 WIFI module
- Onboard relay: 5v.10a/250v ac, 10a/30v dc
- Can connect 5 clients at the same time on AP mode
- The module has two work modes: Cell phone, carry on Wi-Fi module and Cell phone and Wi-Fi module carry on the same router
- Used in mobile phone, Wi-Fi module equipped with one router and control relay by APP
- Maximum transmission distance of 400 m when cell phone carry on wifi module directly, in the open environment
- Transmission distance depends on routers signal intensity when wifi and cell phone is carrying on the same router
- IN+, IN_: 5V power input
- TX, RX, and GND: serial port debug pins
- Baud rate: 115200
- Provide diode effusion protection
- Short response time
- Dimension: 45*28mm
SWIVEL INFRARED MOTION SENSOR OCCUPANCY SWITCH
- Power frequency: 50~60Hz
- Control light: <3 LUX ~ 2000 Lux (Adjustable)
- Time-Delay: Minimum:8sec±3sec to a Maximum:7min±2min
- Power source: 100V/AC-130V/AC <=> 220V/AC-240V/AC
- 1200W(220V/AC-240V/AC) - 800W(100V/AC-130V/AC)
- Power consumption:0.45W(static 0.1W)
- Detection range: 180°
- Detection distance: 12 meters maximum at less than 24°C
- Working temperature:-20 to 40°C
- Working humidity: Less than 93% Relative Humidity
- Suggested Installation height: 0.5 meter to 3.5 meters
- Detection motion speed: 0.6 to 1.5 meters per second
- Identify day and night automatically -
- Power and detection indication
- Time-delay added continually
- Time-delay adjustment according to the customer desire. The minimum time is 8sec±3sec and the maximum is 7min±2min.
- Locking function: the sensor will keep load lighting when power is shut off for 2 seconds and then on. When power is shut off for 4 seconds and then on, sensor will resume automation.