Showing all 12 results

8520 8.5x20mm Coreless Motor + 75mm Propeller for Micro FPV RC Quadcopter

  • Motor Diameter: 8.5mm
  • Motor Length: 20mm
  • Shaft Diameter: 1.0mm
  • Cable Length: 60mm
  • Weight: about 5g
  • Operating Voltage range: 3v to 3.7v DC
  • Rated Speed - 39000 RPM
  • Propeller length: 75mm
  • This coreless motor supports 1S battery.
  • Ideal for mini quadcopter projects weighing below 60 grams

CC3D flight Control

  • Powerful STM32 32-bit microcontroller running at 90 MIPS with 128KB Flash and 20KB RAM.
  • 3-axis high-performance MEMs gyros and 3-axis high-performance MEMs accelerometer.
  • Tiny 36 x 36 mm 4 layer PCB for superior electrical noise reduction and flight performance.
  • Software support for Windows, Mac, and Linux.
  • Supported by powerful OpenPilot GCS
  • 10 PWM outputs to servos or ESC’s, or for camera stabilization
  • Direct high-speed USB support with no drivers required, a true plug and play device.
  • Spectrum satellite receiver support.
  • Futaba S-BUS hardware support.
  • With a function of being directly plugged into the satellite receiver
  • 10 PWM outputs to servos or ESC’s, or for camera stabilization
  • Innovative Flexi-port technology for superior port flexibility.
  • 4Mbits on-board EEPROM for configuration storage.

EMAX BLHELI 12Amp ESC for Quadcopter / Drones

  • Based on BL Heli firmware.
  • ESC Type: Brushless.
  • Built in linear or switched BEC.
  • Constant Current: 12A
  • Burst Current: 15A
  • BEC Mode: Linear BEC : 5v / 1A
  • Lipo Cells: 2-4
  • Constant Current: 12A.
  • Support: One-shot 125 Protocol.
  • Includes low voltage protection, over heat protection, and self-check functions.
  • Separate power supply for MCU and BEC, helping eliminate magnetic interference.
  • Fully programmable by any standard programming card or directly from your transmitter.
  • Customisable throttle range.
  • Weight: 11g
  • Dimension: 42x20x8mm

FlySky 2.4Ghz 6CH Receiver

  • Item Name: FS-R6B Receiver
  • Brand Name: Flysky
  • Power input: 4.0 -6.5 V DC
  • RF power: less than 20DBm
  • Modulation: GFSK
  • Code type: PCM
  • Sensitivity: 1024
  • PWM channels: 6
  • Protocol: AFHDS
  • Distance: >150m
  • Antenna type: Built-in antenna
  • Low voltage warning: LED
  • Charger port
  • Certificate: CE,FCC,RoHS
  • Dimension: 30*25*8mm
  • Weight: 25g

GPS Ublox Neo 6M TTL

450.00
  • Supply voltage: 3.3 V
  • 5Hz position update rate
  • Operating temperature range: -40 TO 85°C
  • UART TTL socket
  • EEPROM to save configuration settings
  • Rechargeable battery for Backup
  • The cold start time of 38 s and Hot start time of 1 s
  • Configurable from 4800 Baud to 115200 Baud rates. (default 9600)
  • -162 dBm tracking sensitivity
  • Support SBAS (WAAS, EGNOS, MSAS, GAGAN)
  • Separated 18X18mm GPS antenna

KK-Mini FLIGHT CONTROLLER

  • IC: Atmega644 PA
  • Gyro/Accelerometer: Auto-level: Yes
  • Input Voltage: 4.8-6.0V
  • AVR interface: standard 6 pins.
  • Signal from Receiver: 1520us (5 channels)
  • Signal to ESC: 1520us
  • LCD size: 24*18mm
  • Mini buttons size: Four 3.3*4.2mm
  • Mounting holes: 30.5x30.5mm
  • Voltage sensor: One red positive pin header for.
  • Input rail: Single row 2.54mm pitch pin header for input signal
  • Firmware Version: 1.6
  • Dimension: 36x36x11.5mm

KK2.1.5 Flight Control

1,999.00
  • IC: Atmega644 PA
  • Input Voltage: 4.8V-6.0V.
  • AVR Interface: Standard 6 Pin.
  • Signal from Receiver: 1520us (5 channels)
  • Signal to ESC: 1520us.
  • Gyro/Accelerometer: MPU 6050
  • Auto Level function
  • Firmware Version: 1.6
  • Dimension: 50.5mm x 50.5mm x 12mm

MARSPOWER MX1806 2280KV BLDC Motor

  • KV: 2280
  • Max thrust: 460g
  • No of cells: 2-3S
  • Framework: 12N14P
  • Suitable Propeller: 5-6”
  • Shaft: 2mm
  • Minimum ESC Specification: 12A Suggested
  • Durable with high quality
  • The 0.2mm core to lower load temperature and increase efficiency
  • Range of use for DJI F330 ZMR250 H250
  • Do every single motor balancing test
  • Japan NMB bearings provide low noise and long life
  • 2mm spindle selection of Kawasaki, Japan, more efficient, less heat
  • NdFeB magnets temperature selection
  • MX1806 (positive thread motor)
  • FPV all configurations life 7-8 minutes!
  • Easy to loosen the nut bombing risk!
  • Low center of gravity design
  • Long-endurance design
  • Dimension: 26.7*23mm
  • Weight: 18gm

MR.RC 12A ESC

  • Input Voltage: 2-3S LIPO
  • Working Current: 12A
  • Burst current (10S): 15A
  • BEC: 5V / 1A Programmable: Yes
  • With stable performance, it is practical and durable
  • Offer you high compatibility, reliability, and stability
  • Throttle range can be set to be compatible with different receivers.
  • Equipped with built-in linear BEC or switch BEC.
  • Easy to install and convenient to use
  • Play a significant role in driving and controlling the motor to complete all kinds of instructions
  • Suitable for 250 Mini four-axis and F330 aircraft, etc
  • Max speed: 210,000 rpm for 2-pole, 70,000 rpm for 6-pole, 35,000 rpm for 12-pole.
  • Dimensions:38 x 20 x 6 mm
  • Weight: 30g

Power Distribution Board

199.00
  • Material: glass fiber
  • Easy connections from the battery to your ESC, video Transmitter, Flight Controller,
  • LED power indicators  
  • Switches to control LEDs, video Transmitter power, etc.
  • Can connect 1-8 ESC.
  • Onboard switching voltage regulator
  • Hole Spacing: 45mm Square and 35mm Square (Compatible with KK 45mm spacing)
  • Dimensions : 50 x 50 x 2 mm.
  • Weight: 8 gm.

QAV250 Quad-copter Frame

799.00
  • Item name: QAV250 Frame Kit
  • Arm plate thickness: 3mm
  • Main material: 3k carbon fiber
  • Wheelbase: 250mm
  • The arm equips dampers for the safe landing.
  • The arm has multiple motor mounting holes.
  • Equips vibration-free mounting bracket for FPV camera.
  • Recommend Propeller: 5 inch
  • Recommend Motor: 1806 2204 2206
  • Recommend ESC: 8A-12A
  • Recommend Battery: 1300Mah-2200Mah

Sunny Sky A2212 980 kv

  • Poor man’s Tiger motor
  • Brand name: Sunnysky
  • KV: 980KV.
  • Framework: 12N14P
  • Operating Current: 6A ~ 18A
  • Peak Current: 14A
  • Shaft: 3mm.
  • thrust: 880g
  • Stator Diameter: 22mm
  • Stator Thickness: 12mm
  • of Stator Slots: 12
  • of Rotor Poles: 14
  • Motor Resistance: 123mΩ
  • Max Continuous Power: 330W
  • Recommended Lipo Batteries: 2-3S
  • Recommended Propeller: 9-10
  • Recommended Esc between 25A and 30A are
  • High-quality bearings for reliable operation.
  • Imported silicon steel coils, and high-quality magnets ensuring longer life and better performance.
  • Generates less heat during operations.
  • Suitable for RC Airplane or Multi rotor helicopter
  • Dimension: 27*30mm
  • Weight: 50gm