I am text block. Click edit button to change this text. Lorem ipsum dolor sit amet, consectetur adipiscing elit. Ut elit tellus, luctus nec ullamcorper mattis, pulvinar dapibus leo.
10000W Original Chips Thyristor Super Power Electronic Regulator can Change Light Speed and Temperature
₹1,700.00 Original price was: ₹1,700.00.₹1,600.00Current price is: ₹1,600.00. inc. GST
- Operating Voltage: AC 220 VDC
- Maximum Power: 10000W
- Voltage Range: AC 0-220V (adjust temperature or light)
- Controller Size: 95.7*56.7*53.8mm
- Panel Size: 74.6*59.8*2.3mm
- Cable Length: 287mm
- New two-way high-power SCR, max current up to 80A.
- Voltage regulator with the peak voltage absorption circuit effectively protects the high-power SCR and has a longer service life.
- Built-in heat sink, thickened to increase the heat sink, good heat dissipation, easy to install.
- 57A high current terminal block, simple wiring, strong button adjustment stability.
- Omron original tact switch, Fairchild original photoelectric coupler, all metal film resistors are stable and durable.
- The value is automatically saved. After power-on, it will automatically start to the last adjusted value.
- Weight: 200gm
Original 10000W Chips Thyristor Super Power Electronic Regulator Designed for Light Speed Temperature Adjustment It has a new two-way large power silicon-controlled rectifier and can handle up to 80A of current. As a result, it’s a viable solution for electric stove wire over-current produced by low resistance during cooling. It can easily alter the output voltage to power electric devices on a scale of 0-100 percent (nonlinear). The heat sink on these power thyristors is broad and thick, allowing for better heat dissipation. This voltage regulator is controlled by a button rather than a potentiometer, which makes it considerably more stable.
The voltage regulator’s long life is ensured by the peak voltage absorption circuit, which protects the high-power thyristor. With 2-way high-power silicon control, these are extremely visible and handy devices. As a result, no external components are required. Water heater heat transfer, lights dimming, tiny motor speed, electric iron thermostat, and more applications employ SCR Voltage Regulators.
Application:
- The new two-way high-power SCR, with a maximum current of 80A, is an ideal solution to the problem of over-current electric wire when cooling is insufficient to generate resistance.
- For the usage of electrical appliances, easily modify the output voltage mains in any adjustment range from 0-100 percent (220V 100 adjustment points, non—). Electric furnaces, water heater heating, lights dimming, tiny motor speed control, and electric iron temperature control are just a few examples. As a result, the effects of dimming, temperature regulation, and pressure regulation can be achieved.
- Used in big appliances with fewer than 10,000 watts of electric power. Because the power has been abundant, common household appliances or small factories are suitable for usage. (Power from inductive or capacitive loads should be minimised; this regulator has a two-way high-power SCR that can be utilised without any additional components, making it highly handy and practical.)

Related products
125 KHz RFID CARD THICK
40A DC MOTOR SPEED REGULATOR PWM CONTROLLER 2000W
- Speed controller model: 40A PWM DC motor speed regulator
- Operating voltage: 10V TO 50V
- Peak current: 40A
- Control power: 0.01-2000W
- Quiescent current: 0.025A
- PWM regulation: 5-100%
- PWM frequency: 12KHz
- Operating temperature: -20 degree to 40 degree Celsius
- Stability in working
- High efficiency
- potentiometer used for speed adjustability
- Dimension: 9*5.1mm
- Weight: 95gm
5V-12V ZVS Induction Low Voltage Heating Power Supply Module Board + Coil
6-30V 1-Channel Power Relay Module with Adjustable Timing Cycle
- Operating voltage: 6 - 30V DC
- 1 Channel delay trigerred relay module
- Delay time: 0.1 second ~ 999 minutes
- Seven Segment Display
- Operating voltage: DC 6V-30V (supports micro USB 5V power supply)
- Trigger signal source: high-level trigger (3V-24V) signal ground and system to improve the system's anti-jamming capability (also short-circuit altogether)
- Output capability: it can control the device within DC 30V 5A or within AC 220V 5A
- Quiescent current: 20mA
- Operating current: 50mA
- Service life: more than 100,000 times
- Working temperature: -40°C-85°C
- With optocoupler isolation, enhanced anti-jamming capability, industrial grade circuit board, set parameters for memory after power failure.
- Dimension: 6.2 * 3.8 * 1.7cm
Afr-2000 G1/4” Air Compressor Water Filter with Regulator Air Tool Cleaning
- Model: AFR2000 (AFR is the model, 2000 refers to the port size)
- Operating Fluid: Air
- Joint pipe bore: G 1/4"
- Range of Adjustable Pressure: 0.05-0.99 MPa
- Adjustable Pressure: 0.99 MPa
- Ensured Pressure Resistance: 1.5 MPa
- Operating Temperature Range: 5℃-60℃
- Filter Grade: 40 µ
- Capacity of Body: 15 cc
- Gauge caliber: G1 / 8
- Material: Metal, plastic
- Discharge water automatically
- Lightweight, small size, easy installation, and maintenance
- No matter the size of the inlet pressure and flow fluctuations, always maintain a stable outlet pressure
- Dimension: 6.29 x 2.75 x 2.75 inch
Kapton Polyimide Heat Resistant/High Temperature/Thermal Tape/SublimationTape 12mm
- Color: Tawny
- Substrate material: Polyimide polymers film
- Glue Type: Silicone
- Substrate material thickness: 0.025mm
- Thickness with adhesive: 0.05mm
- Heat resistance: about 280°C
- Size:1/2" x 100ft (13mm*30m)
- Elongation: 35 %
- Temperature Range:-73°C – 260°C (-99°F - 500°F)
- High insulation, high temperature resistance, acid and alkali-resistance, low electrolysis, mechanically sound, crocking resistance, tear-resistance, without rest on surface when tear.
- Ideal for protecting sensitive printed circuit board (PCB) components,great for sublimation, HTV, heat press and heat transfer.
- Also extensive use as electrical insulation for transformer, motor, coil, capacitor and frequency conversion power supply in electronic industry.
MFRC522 RFID 13.56MHz
- Integrated MFRC522 module 13.56MHz RFID module
- Operating voltage: 2.5V to 3.3V
- Supports SPI, I2C protocol, UART communication
- Maximum data rate: 10Mbps
- Read range: 5cm
- Current consumption: 13-26 mA
- Power down mode consumption: 10mA
- Low cost and low voltage device
- Advanced modulation and demodulation concept completely integrated into all types of 13.56MHz passive contactless communication method and protocol
- 14443A compatible transponder signal
- Can be directly loaded into various reader molds
- Dimension: 12.3*11.9*3.8cm
- Weight: 20gm
RFID Tag Key Fob Keyfobs 125Khz
- Material: ABS
- Response Frequency: 125Khz
- 2kbps ASK
- Diameter: ~29mm
- Range: 0-10 cm
- Manchester encoding
- 32-bit unique ID
- Uses TK4100 chip which is compatible with EM4100
- 64-bit data stream [Header+ID+Data+Parity]
- Read Time: 1-2ms
- Operating Temperature: -20c ~ 85 degree C
- Endurance:> 100,000 times
- 64-bit data stream [Header+ID+Data+Parity]
- Designed for the RFID 125KHZ duplicator. can copy all the ID card, such as Access Card, District Card, Parking etc
- Dimension: 43.7×30.5×5.3mm

Reviews
There are no reviews yet.