Showing 2233–2244 of 2265 results

Xbee Module S2C XBP24CZ7UIT-004

₹1,175.00 inc. GST
  • Protocol: ZigBee
  • Modulation: DSSS
  • Frequency: 2.4GHz
  • Data Rate: 1Mbps
  • Power: Output 18dBm
  • Sensitivity: 101dBm
  • Serial Interfaces: SPI, UART
  • Antenna Type: Antenna Not Included, U.FL
  • Transceiver chipset: Silicon Labs EM357 SoC
  • Operating voltage: 2.7V-3.6V
  • Current Receiving: 31mA ~ 45mA
  • Current Transmitting: 120mA
  • Mounting Type Through Hole
  • Operating Temperature: -40°C ~ 85°C
 

Xbee Pro S2C Module XBP24CZ7WIT-004

₹2,500.00 inc. GST
  • Operating voltage: 2.7V-3.6V
  • Max data rate: 250kbps
  • 63mW output (+17dBm)
  • Range: 1 mile (1600m)
  • ADC Channels: 6 10-bit ADC input pins
  • Digital I/O: 8
  • 128-bit encryption
  • Transmit Current: 120mA at 3.3VDC
  • Receive current: 31mA at 3.3VDC
  • Data Rate: RF 250Kbps, serial up to 1Mbps
  • Indoor/urban range up to 300ft (90m)
  • outdoor/RF line of sight range up to 2miles (3200m)
  • Transmit power is 63mW (+18dBm)
  • Receiver sensitivity is -101dBm
  • Local or over-air configuration
  • AT or API command set
  • External Antenna Required
  • Firmware upgrades via UART, SPI or over the air (OTA)
  • ISM 2.4GHz frequency band, DSSS (direct sequence spread spectrum) interference immunity
  • Dimension: 2.438cm x 3.294cm

xcluma Xilinx Xc2C32A Cpld Development Learning Board

₹1,300.00 inc. GST
  • On-board XC2C32A chip.
  • On-board JTAG interface.
  • On-board 50MHZ active crystals.
  • With 4 programmable LEDs.
  • With AMS1117-3.3 and AMS1117-1.8 two kinds of LDO chip.
  • 5V power supply with a switch.
  • All IO are leaded out

XF40 750W 48V MXUS Electric Bike Bicycle Rear wheel Hub motor DIY Conversion Kit

₹16,500.00 inc. GST
  • Model: MXUS Motor XF40
  • Rated Voltage: 48V,
  • Rated Power: 750W,
  • Magnet height: 27H/30H,
  • Wheel size: 20-28inch
  • Rated Speed:32km/h
  • Weight: 6kg
  • Open size: 135mm
  • Surface: lace/Silver,
  • Compatible Brake type: Disc brake.

XH-W1219 12V Digital Display Temperature Controller Module W/NTC Waterproof Temperature Sensor

₹199.00 inc. GST
  • Control Range: -50~110 °C
  • Control Precision: 0.1 °C
  • Measuring Input: NTC10K waterproof sensor L=0.5m.
  • High-Temperature Alarm: -49~110 °C
  • Input Voltage: DC 12V
  • Output Type: Relay output 10A (max)
  • Return Difference Setting: 0.1~30 °C
  • Delay Starting: 0-10min
  • Temperature Calibration: -10~10 °C

XH-W1401 12V Digital Led Thermostat Module Temperature Controller With Display

₹500.00 inc. GST
  • Model: XH-W1401
  • Power Supply: DC12V
  • Thermostat Range: -9℃ to 99℃
  • Thermostat Accuracy: 1℃
  • Output : Electric relay output ,capacity 220V 10A/12V 10A
  • For cooling or heating temperature control
  • Simple Temperature Sensor Module with 12V Relay
  • Imported High-Speed single-chip microcomputer.
  • Three Display output status indicator.
  • Automatically judge heating and cooling according to set temperature.
  • Used in various temperature control, water temperature control, incubators, etc.
  • Refresh Rate: 0.5 Sec
  • Dimension:” 78*55mm
  • Weight: 0.040 kg

XH-W3001 DC 12V 120W Digital Microcomputer Thermostat Switch

₹350.00 inc. GST
  • Rated Current: 10 Amp Max.
  • Measurement Input: NTC10K
  • Temp Probe Cable Length: 1 Meter
  • Power Supply: DC12V
  • Load Power: 120W
  • Easy to install
  • Output type: Direct output
  • Output capacity: max 10A
  • Temperature setting upper and lower limits
  • Temperature measuring range: -50~110°C
  • Temperature control range: -50~110°C
  • Control precision: up to 0.1°C
  • Up key: Press once to display the start temperature. Long press to set start temperature.
  • Down key: Press once to display the stop temperature. Long press to set stop temperature.
  • Temperature setting upper and lower limits
  • Simple operation, suitable for seafood machines.
  • Dimensions 60 x 45 x 31 (mm)
  • Weight: 55gm

XH-W3001 DC 24V 240W Digital Temperature Controller Microcomputer Thermostat Switch

₹650.00 inc. GST
  • Rated Current: 10 Amp Max.
  • Measurement Input: NTC10K
  • Temp Probe Cable Length: 1 Meter
  • Power Supply: DC12V,DC 24V
  • Load Power: 120/240/1500W
  • Easy to install
  • Output type: Direct output
  • Output capacity: max 10A
  • Temperature setting upper and lower limits
  • Temperature measuring range: -50~110°C
  • Temperature control range: -50~110°C
  • Control precision: upto 0.1°C
  • Up key: Press once to display the start temperature. Long press to set start temperature.
  • Down key: Press once to display the stop temperature. Long press to set stop temperature.
  • Temperature setting upper and lower limits
  • Dimensions 60 x 45 x 31 (mm)
  • Weight: 55gm

XL4015 5A STEP DOWN WITH DISPLAY

₹500.00 inc. GST
  • Module nature: non-isolated buck module ( BUCK )
  • Input voltage: 4-38V
  • Output voltage: 1.25-36V
  • Output current: 0-5A, it is recommended to use within 4.5A
  • 14 Digital I/O Pins
  • Output power: It is recommended to use within 75W, please add a heat sink if it exceeds 50W
  • Working temperature: -40 degree to + 85 degrees
  • Working frequency: 180KHz
  • Conversion efficiency: up to 96% Load adjustment rate: S ( I ) ≤ 0.8%
  • Voltage adjustment rate: S ( u ) ≤ 0.8%
  • LED to indicate power status
  • Short circuit protection
  • Over-temperature protection
  • Dimension: 54mm * 23mm wide *18mm

XL4015 5A STEP DOWN MODULE

₹450.00 inc. GST
  • Module nature: non-isolated buck module ( BUCK )
  • Input voltage: 4-38V
  • Output voltage: 1.25-36V
  • Output current: 0-5A, it is recommended to use within 4.5A
  • 14 Digital I/O Pins
  • Output power: It is recommended to use within 75W, please add a heat sink if it exceeds 50W
  • Working temperature: -40 ~ + 85 degrees
  • Working frequency: 180KHz
  • Conversion efficiency: up to 96% Load adjustment rate: S ( I ) ≤ 0.8%
  • Voltage adjustment rate: S ( u ) ≤ 0.8%
  • Power indicator: No
  • Short circuit protection
  • Over-temperature protection
  • Dimension: 54mm * 23mm wide *18mm

XL4015 5A STEP DOWN WITH HEAT SINK

₹250.00 inc. GST
  • Module nature: non-isolated buck module ( BUCK )
  • Input voltage: 4-38V
  • Output voltage: 1.25-36V
  • Output current: 0-5A, it is recommended to use within 4.5A
  • 14 Digital I/O Pins
  • Output power: It is recommended to use within 75W, please add a heat sink if it exceeds 50W
  • Working temperature: -40 degree + 85 degrees
  • Working frequency: 180KHz
  • Conversion efficiency: up to 96% Load adjustment rate: S ( I ) ≤ 0.8%
  • Voltage adjustment rate: S ( u ) ≤ 0.8%
  • Power indicator
  • Short circuit protection
  • Over-temperature protection
  • Dimension: 54mm * 23mm wide *18mm

XL4432 LORA Sensor Module

₹650.00 inc. GST
  • Frequency range: 433.92M
  • High sensitivity up to-121dBm
  • Maximum output power: 20dBm
  • Data transfer rate: 0.123-256 kbps
  • FSK, GFSK, and OOK modulation mode
  • 1.8-3.6V power supply
  • Ultra-Thin Power Off Mode
  • Digital signal strength indicator received (RSSI)
  • Synchronization alarm function
  • Automatic antenna connection and bidirectional switch control
  • The configurable data package structure
  • Before sync signal detection
  • 64 bytes RX data record (FIFO)
  • Low power tests
  • Temperature detection and 8-bit analog to digital converter
  • Operating temperature range: -20 ~ + 60 C