TL081 JFET-Input Operational Amplifier IC
TL084 General Purpose JFET Quad Operational Amplifier IC
- Supply Voltage Max: ±18V
- Input Voltage: ±15V
- Differential Input Voltage: ±30V
- Power Dissipation: 680mW
- Input Offset Voltage: 3mV
- Input Offset Current: 5pA
- Input Bias Current: 30pA
- Slew Rate: 16V/µs
- Package: DIP-14
- General purpose JFET quad operational amplifier
- Wide common-mode and differential voltage range
- Low input bias and offset current
- Output short-circuit protection
- Internal frequency compensation
TL494 Pulse Width Modulation Controller IC
- Supply Voltage: 7 to 40V
- Collector Output Voltage: 40V
- Collector Output Current: 200mA
- Oscillator frequency Max: 300KHz
- Output Regulation: 1mV
- Input Offset Voltage: 2mV
- Input Offset Current: 25nA
- Input Bias Current: 0.2µA
- Pulse Width Modulation Controller
- Uncommitted Outputs for 200mA Sink or Source Current
- Output Control Selects Single-Ended or Push-Pull Operation
- Internal Circuitry Prohibits Double Pulse at Either Output
TNY176PN Off-line Switcher IC
- Drain Voltage: -0.3 to 650V
- Drain Peak Current: 720mA
- ENABLE Voltage: -0.3 to 9V
- ENABLE Current: 100mA
- ON State Resistance (max): 16Ω
- Energy Efficient, Offline Switcher with Enhanced Flexibility and Extended Power Range
- 650 V rating optimized for non-active PFC applications
- Simple ON/OFF control, no loop compensation needed
- Pin-out simplifies heat sinking to the PCB
- SOURCE pins are electrically quiet for low EMI
- Package: DIP-8C
TNY177PN Off-line Switcher IC
- Drain Voltage: -0.3 to 650V
- Drain Peak Current: 880mA
- ENABLE Voltage: -0.3 to 9V
- ENABLE Current: 100mA
- ON State Resistance (max): 9Ω
- Package: DIP-8C
- Energy Efficient, Offline Switcher with Enhanced Flexibility and Extended Power Range
- 650 V rating optimized for non-active PFC applications
- Simple ON/OFF control, no loop compensation needed
- Pin-out simplifies heat sinking to the PCB
- SOURCE pins are electrically quiet for low EMI
TNY254PN Off-line Switcher IC
TNY256PN Off-line Switcher IC
TNY264PN Off-line Switcher IC
- Drain Voltage: -0.3 to 700V
- Drain Peak Current: 400mA
- ENABLE Voltage: -0.3 to 9V
- ENABLE Current: 100mA
- ON State Resistance (max): 32Ω
- Package: DIP-8B
- Fully integrated auto-restart for short circuit and open loop fault protection – saves external component costs
- Frequency jittering dramatically reduces EMI (~10 dB) – minimizes EMI filter component costs
- Lowest component count switcher solution
TNY266PN Off-line Switcher IC
- Drain Voltage: -0.3 to 700V
- Drain Peak Current: 560mA
- ENABLE Voltage: -0.3 to 9V
- ENABLE Current: 100mA
- ON State Resistance (max): 16Ω
- Package: DIP-8B
- Fully integrated auto-restart for short circuit and open loop fault protection – saves external component costs
- Frequency jittering dramatically reduces EMI (~10 dB) – minimizes EMI filter component costs
- Lowest component count switcher solution
TNY267PN Off-line Switcher IC
- Drain Voltage: -0.3 to 700V
- Drain Peak Current: 720mA
- ENABLE Voltage: -0.3 to 9V
- ENABLE Current: 100mA
- ON State Resistance (max): 9Ω
- Package: DIP-8B
- Fully integrated auto-restart for short circuit and open loop fault protection – saves external component costs
- Frequency jittering dramatically reduces EMI (~10 dB) – minimizes EMI filter component costs
- Lowest component count switcher solution
TNY268PN Off-line Switcher IC
- Drain Voltage: -0.3 to 700V
- Drain Peak Current: 880mA
- ENABLE Voltage: -0.3 to 9V
- ENABLE Current: 100mA
- ON State Resistance (max): 6Ω
- Package: DIP-8B
- Fully integrated auto-restart for short circuit and open loop fault protection – saves external component costs
- Frequency jittering dramatically reduces EMI (~10 dB) – minimizes EMI filter component costs
- Lowest component count switcher solution
TNY276PN Off-line Switcher IC
- Drain Voltage: -0.3 to 700V
- Drain Peak Current: 720mA
- ENABLE Voltage: -0.3 to 9V
- ENABLE Current: 100mA
- ON State Resistance (max): 16Ω
- Simple ON/OFF control, no loop compensation needed
- ON-time extension – extends low line regulation range/hold-up time to reduce input bulk capacitance
- Frequency jittering reduces EMI filter costs
- Pin-out simplifies heat sinking to the PCB
- SOURCE pins are electrically quiet for low EMI
- Package: DIP-8B
TNY278PN Off-Line Switcher IC
- Drain Voltage: -0.3 to 700V
- Drain Peak Current: 1040mA
- ENABLE Voltage: -0.3 to 9V
- ENABLE Current: 100mA
- ON State Resistance (max): 6Ω
- Output Frequency Max: 140KHz
- Package: DIP-8C
- Energy Efficient Off-Line Switcher
- Simple ON/OFF control, no loop compensation needed
- ON-time extension – extends low line regulation range/hold-up time to reduce input bulk capacitance
- Frequency jittering reduces EMI filter costs
- Pin-out simplifies heat sinking to the PCB
- SOURCE pins are electrically quiet for low EMI
TNY279PN Off-line Switcher IC
- Drain Voltage: -0.3 to 700V
- Drain Peak Current: 1200mA
- ENABLE Voltage: -0.3 to 9V
- ENABLE Current: 100mA
- ON State Resistance (max): 4.5Ω
- Simple ON/OFF control, no loop compensation needed
- ON-time extension – extends low line regulation range/hold-up time to reduce input bulk capacitance
- Frequency jittering reduces EMI filter costs
- Pin-out simplifies heat sinking to the PCB
- SOURCE pins are electrically quiet for low EMI
- Package: DIP-8B
TNY280PN Off-Line Switcher IC
- Drain Voltage: -0.3 to 700V
- Drain Peak Current: 1360mA
- ENABLE Voltage: -0.3 to 9V
- ENABLE Current: 100mA
- ON State Resistance (max): 3Ω
- Output Frequency Max: 140KHz
- Package: DIP-8C
- Energy Efficient Off-Line Switcher
- Simple ON/OFF control, no loop compensation needed
- ON-time extension – extends low line regulation range/hold-up time to reduce input bulk capacitance
- Frequency jittering reduces EMI filter costs
- Pin-out simplifies heat sinking to the PCB
- SOURCE pins are electrically quiet for low EMI
TOP204Y Off-line PWM Switch IC
- Supply Current: 1.4 mA
- Supply Voltage: 85-265VAC
- Output Voltage: 5.8 V
- Power (Watts): 50W
- Switching Frequency-Max: 100 kHz
- Package: TO-220
- Built-in start-up and current limit reduce DC losses • Low capacitance 700 V MOSFET cuts AC losses • CMOS controller/gate driver consumes only 6 mW
- 70% maximum duty cycle minimizes conduction losses.
- Low Cost Replacement for Discrete Switchers.
- Easily interfaces with both opto and primary feedback .
- Supports continuous or discontinuous mode of operation
TOP221PN Off-line PWM Switch IC
- Supply current: 1.2mA
- Supply Voltage: 85-265VAC
- Output Voltage: 5.7 V
- Power (Watts): 9W
- Switching Frequency-Max: 100 kHz
- Package: DIP-8
- Lowest cost, lowest component count switcher solution
- Cost competitive with linears above 5 W
- Very low AC/DC losses – up to 90% efficiency
- Built-in Auto-restart and Current limiting
- Latching Thermal shutdown for system level protection
- Implements Flyback, Forward, Boost or Buck topology
- Works with primary or opto feedback
- Stable in discontinuous or continuous conduction mode
- Source connected tab for low EMI
- Circuit simplicity and Design Tools reduce time to market
TOP222YN Off-line PWM Switch IC
- Supply Current: 1.2 mA
- Output Voltage: 5.7 V
- Power (Watts): 25W
- Output Current-Max: 0.5500 A
- Switching Frequency-Max: 110 KHz
- Lowest cost, lowest component count switcher solution.
- Cost competitive with linears above 5 W.
- Very low AC/DC losses – up to 90% efficiency.
- Built-in Auto-restart and Current limiting.
- Latching Thermal shutdown for system level protection.
- Circuit simplicity and Design Tools reduce time to market
- Package: TO-22
TOP223Y Offline PWM Switcher IC
- Supply Current: 1.2 mA
- Supply Voltage: 85-265VAC
- Output Voltage: 5.7 V
- Power (Watts): 50W
- Switching Frequency: 100 kHz
- Lowest cost, lowest component count switcher solution
- Cost competitive with linears above 5 W
- Very low AC/DC losses – up to 90% efficiency
- Built-in Auto-restart and Current limiting
- Latching Thermal shutdown for system level protection
- Implements Flyback, Forward, Boost or Buck topology
- Works with primary or opto feedback
- Stable in discontinuous or continuous conduction mode
- Source connected tab for low EMI
- Circuit simplicity and Design Tools reduce time to market
- Package: TO-220
TOP243PN Off-line Switcher IC
- Supply Current: 1.6 mA
- Supply voltage range: 85-265VAC
- Power: 25W
- Output Voltage: 12 V
- Switching Frequency: 132 kHz
- Package: TO-DIP-8
- Extended power range for higher power applications
- No heatsink required up to 34 W using P/G packages.
- Features eliminate or reduce cost of external components.
- Fully integrated soft-start for minimum stress/overshoot.
- Externally programmable accurate current limit.
- Wider duty cycle for more power, smaller input capacitor .
- Separate line sense and current limit pins on Y/R/F packages
TOP243YN Off-line Switcher IC
TOP244YN Off-line Switcher IC
TOP245YN Off-line Switcher IC
TOP246Y Off-line Switcher IC
TOP247YN Off-line Switcher IC
TOP249YN Off-line Switcher IC
TOP257YN Off-line Switcher IC
TOP258PN Off-line Switcher IC
TOP258YN Off-line Switcher IC
- Supply Voltage: -0.3-9V
- Output Voltage: 700 V
- Output current: 6.88A
- Power: 195W
- Switching Frequency-Max: 132 kHz
- Package: TO-220-7C
- Lowest cost, lowest component count switcher solution
- Stable in discontinuous or continuous conduction mode
- Source connected tab for low EMI
- Circuit simplicity and Design Tools reduce time to market
TOP261EN Off-line Switcher IC
TOP261YN Off-line Switcher IC
- Supply Voltage: -0.3-9V
- Output Voltage: 700 V
- Power: 333W
- Switching Frequency-Max: 132 kHz
- Package: TO-220-7C
- Lowest cost, lowest component count switcher solution
- Stable in discontinuous or continuous conduction mode
- Source connected tab for low EMI
- Circuit simplicity and Design Tools reduce time to market
TS4B05G Flat Bridge Rectifier 4A 50V
TSOP 1738 IR Receiver
- Supply Voltage: 5 V
- Operating current: 5mA
- Power consumption: 0.4 to 1.0 mA
- Ee irradiation: 0.35 mW/m2 typ.
- Angle of detection: 90
- Dimensions of the casing (mm): 12.5 x 10 x Thickness 5.8
- Temperature range: -25 C to +85 C
- Can detect IR signals from Remotes (38kHz)
- High Range and wide coverage area.
- Will respond only to IR signals, due to high immunity against ambient light
- Low power consumption
- Has in-built pre amplifier
- TTL and CMOS compatible
TSOP1838 IR Reciever Metal Small
- Supply voltage: 2.7 to 5.5V
- Reception Distance: 18 Meters
- P.F Centre Frequency: 38KHz
- Supply Current: 0.4 to 1.5mA
- Reception angle :+/- 45 degrees
- VOH (6V Vcc): 4.5V
- VOL (5V Vcc): 0.4V
- Photo detector and preamplifier in one package
- Internal filter for PCM frequency
- TTL and CMOS compatibility
- Output active low
- Improved shielding against electrical field disturbance
- Suitable burst length: 6 cycles/burst
- Low power consumption.
- Immunity to ambient light is high
