C&S Switch Disconnector Fuse unit
C&S TC1D2510 Power Contactor
C106M Thyristor 600V 4A
- Peak Repetitive Forward and Reverse Blocking Voltage: 600V
- RMS Forward Current: 4A
- Average Forward Current: 2.55A
- Holding Current: 3mA
- Non-repetitive Surge On-state Current: 20A
- Package: TO-225AA
- Power Rated at Economical Prices
- Practical Level Triggering and Holding Characteristics
- Flat, Rugged, Thermo pad Construction High Heat Dissipation and Sensitive Gate Triggering
- These are Pb—Free Device'
- Glassivated Surface for Reliability and Uniformity
CA-3110 Dual Channel Stereo Class Amplifier Board
CA3130A Operational Amplifier IC
CA3140 Operational Amplifier IC
CA741C 0.9MHz Single High Gain Operational Amplifier IC
CAN BUS SHIELD
CAN Bus Shield
- Implements CAN V2.0B at up to 1 Mb/s
- Industrial standard 9 pin sub-D connector
- OBD-II and CAN standard pinout selectable.
- Changeable chip select pin
- Changeable CS pin for TF card slot
- Changeable INT pin
- Screw terminal that easily to connect CAN_H and CAN_L
- Arduino Uno pin headers
- Grove connectors (I2C and UART)
- SPI Interface up to 10 MHz
- Standard (11 bit) and extended (29 bit) data and remote frames
- Two receive buffers with prioritized message storage
Capacitor Touch Dimmer, Constant Voltage LED Stepless Dimming, PWM Control Board
- Voltage range: 4V to 5V
- Maximum output current: 500mA
- Hole distance: 16 mm
- Aperture: 5 mm
- The lamp brightness can be adjusted by requirement, it is very to operate.
- It can touch in medium protection, such as glass, acrylic, plastic, ceramics, and so on, which is very safe.
- Anti power and phone interference, the EFT can reach above +/-2KV; the touch response sensitivity and reliability will not be affected by the close distance or multi-angle mobile phone interference.
- Dimming mode: Non-polar PWM dimming.
- PCB size: 23 x 20mm