ADC0809 8-Bit µP Compatible ADC with 8-Channel Multiplexer IC
- 8-Bit µP Compatible A/D Converter with 8-Channel Multiplexer
- Resolution: 8 bit
- Supply Current: 300µA
- No. of Pins: 28
- Input Channel Type: Single Ended
- Data Interface: Parallel
- Conversion Time: 100µs
- No. of Bits: 8 bit
- No. of Channels: 8
- Maximum Power Dissipation: 15mW
- Operating Temperature Range: -40°C to +85°C
- Supply Voltage Range: 4.5V to 6V
ADG509 4-Channel Analog Multiplexer IC
- 4 Channel Analog Multiplexer
- Power Supply Type: Single/Dual
- Supply Voltage Range (Single): 10.8V to16.5V
- Supply Voltage Range(Dual): ±10.8V to ±16.5V
- High Level Output Current Max. : 20mA
- Power Dissipation Max. : 470mW
- Propagation Delay Max.: 300ns
- On Resistance Max.: 700Ω
- Supply Current Max.: 1.5mA
- Package: DIP-16
ADP3168 6-Bit, Programmable 2-, 3-, 4-Phase Synchronous Buck Controller IC
- 6-Bit, Programmable 2-, 3-, 4-Phase Synchronous Buck Controller
- Selectable 2-, 3-, or 4-phase operation at up to 1 MHz per phase
- ±10 mV worst-case differential sensing error over temperature
- Logic-level PWM outputs for interface to external high power drivers
- Active current balancing between all output phases
- Built-in Power Good/crowbar blanking supports
- On-the-fly VID code changes
- 6-bit digitally programmable 0.8375 V to 1.6 V output
- Programmable short-circuit protection with programmable latch-off delay
ADP3180 6-Bit Programmable 2-, 3-, 4-Phase Synchronous Buck Controller IC
- 6-Bit Programmable 2-, 3-, 4-Phase Synchronous Buck Controller
- Selectable 2-, 3-, or 4-Phase Operation at up to 1 MHz per Phase
- ±14.5 mV Worst-Case Differential Sensing Error over Temperature
- Logic-Level PWM Outputs for Interface to External High Power Drivers
- Active Current Balancing between All Output Phases
- Built-In Power Good/Crowbar Blanking Supports On-the-Fly VID Code Changes
- 6-Bit Digitally Programmable 0.8375 V to 1.6 V Output
- Programmable Short Circuit Protection with Programmable Latch-Off Delay
ADP3188 6-Bit Programmable 2 or 3 or 4-Phase Synchronous Buck Controller IC
- 6-Bit Programmable 2-/3-/4-Phase Synchronous Buck Controller
- Selectable 2-, 3- or 4-phase operation at up to 1 MHz per phase
- ±9.5 mV worst-case differential sensing error over temperature
- Logic-level PWM outputs for interface to external high power drivers
- Active current balancing between all output phases
- Built-in power good/crowbar blanking supports on-the-fly VID code changes
- 6-bit digitally programmable 0.8375 V to 1.6 V output
- Programmable short-circuit protection with programmable latch-off delay
ADXL 335 Accelerometer IC
- 3-axis sensing
- Small, low profile package
- 4 mm × 4 mm × 1.45 mm LFCSP
- Low power : 350 μA (typical)
- Single-supply operation: 1.8 V to 3.6 V
- 10,000 g shock survival
- Excellent temperature stability
- BW adjustment with a single capacitor per axis
- RoHS/WEEE lead-free compliant
- 8V- 3.6V single-supply operation
- Integrated X, Y, and Z axis accelerometer on a single chip
- X and Y axis has a 0.5Hz to 1600Hz bandwidth
- Z axis has a 0.5Hz to 550Hz bandwidth
- Hermetically sealed for temp and humidity resistance
AP8022-AC-DC OFF LINE SMPS PRIMARY SWITCHER IC
- 85v to 265v wide range AC voltage input
- A 700v MOSFET on the same silicon chip
- Auto start up with high voltage current source
- PWM with current mode control
- 9v to 38v wide range VCC voltage
- Fixed 60KHz switching frequency
- Automatic skip cycle mode in low load condition.
- Over temperature, over current and over voltage protection
- Auxiliary under voltage lockout with hysteresis
- Available in SOP8 and DIP8 Package
ATMEGA128A Atmel Microcontroller IC
- Flash (Kbytes): 128 Kbytes
- Pin Count: 64
- Operating Freq. (MHz): 16 MHz
- CPU: 8-bit AVR
- Max I/O Pins: 53
- Ext Interrupts: 8
- SPI: 1
- UART: 2
- ADC channels: 8
- SRAM (Kbytes): 4
- EEPROM (Bytes): 4096
- Operating Voltage (Vcc): 2.7 to 5.5V
- High-performance, Low-power Atmel AVR 8-bit Microcontroller
- Advanced RISC Architecture – 133 Powerful Instructions - Most Single-clock Cycle Execution – 32 × 8 General Purpose Working Registers + Peripheral Control Registers – Fully Static Operation – Up to 16MIPS Throughput at 16MHz – On-chip 2-cycle Multiplier
- High Endurance Non-volatile Memory segments – 128Kbytes of In-System Self-programmable Flash program memory – 4Kbytes EEPROM – 4Kbytes Internal SRAM – Write/Erase cycles: 10,000 Flash/100,000 EEPROM – Data retention: 20 years at 85°C/100 years at 25°C(1) – Optional Boot Code Section with Independent Lock Bits
- In-System Programming by On-chip Boot Program
- True Read-While-Write Operation – Up to 64 Kbytes Optional External Memory Space – Programming Lock for Software Security – SPI Interface for In-System Programming
- JTAG (IEEE std. 1149.1 Compliant) Interface – Boundary-scan Capabilities According to the JTAG Standard – Extensive On-chip Debug Support Atmel-8151J-8-bit AVR Microcontroller_Datasheet_Complete-09/2015 – Programming of Flash, EEPROM, Fuses and Lock Bits through the JTAG Interface
